Hello,
I reopen this topic because I would like to use the SensComp 6000 you used for your design. Mtwieg, you said that your output signal is 24Vpp but in theory, the signal could be up to 200Vpp; am I right? Also one need a 200V DC bias...
I found op amps to amplify arbitrary signal (I need to output signal up to 100KHz) between 0 and 350V (using **broken link removed**) but I am unable to find proper dc dc converter to power it at 350V (Also I would like that the input voltage of my board is not higher than 24V)...
Any ideas?
If it is impossible to find such component, how did you do your step-up transformer?
Do you know how much current is needed?
thanks in advance!