Sorry. I had uploaded the wrong file earlier.Not the same circuit that produced the error messages in post #1. Now P3 and P4 have unconnected substrate pin. Check the schematic design.
can you tell me If in the given circuit .meas V(out)* I(load ) will give proper power value? Or do you have any other suggestions for the formula that can be used?Why .step? 1 cycle should be sufficient for measurement. The interval start and end should not coincide with a signal edge. You can do the measurement in waveform viewer if you set the plot limits to an integer multiple of cycles. But .measure statement will do well.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?