Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Figure is the o/p of the processed signal in Freq domain.. I would like to remove the freq component @ 0.07 in the x-axis...pls tell me, in general to remove the procedure to remove the first freq component.....
hi,
The signal shown in the fig is the output fft of the some processed signal..
But after processing i should get only single freq ... but i m getting traces of other signal.. i would like to filter out the signal by applying some threshold to the signal... so that signal with amplitude lesser than the threshold should not appear .. but i dont no how to proceed ...?
i want to know weather my approach is correct...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
[/