Kaka_fsk
Newbie level 5
The follwing Error always appear when programming. The sw I use is ise10.1,
Anyone can tell me how to fix it? Thanks.
Maximum TCK operating frequency for this device chain: 0.
Validating chain...
Boundary-scan chain validated successfully.
'2': Erasing device...
PROGRESS_START - Starting Operation.
'2': Erasure completed successfully.
'2': Programming device...
done.
'2': Putting device in ISP mode...done.
'2': Putting device in ISP mode...done.
'2': Verifying device...Failed at address, 1600'2': Verification Terminated
'2': Programming of user selected options failed.
PROGRESS_END - End Operation.
Elapsed time = 13 sec.
Anyone can tell me how to fix it? Thanks.
Maximum TCK operating frequency for this device chain: 0.
Validating chain...
Boundary-scan chain validated successfully.
'2': Erasing device...
PROGRESS_START - Starting Operation.
'2': Erasure completed successfully.
'2': Programming device...
done.
'2': Putting device in ISP mode...done.
'2': Putting device in ISP mode...done.
'2': Verifying device...Failed at address, 1600'2': Verification Terminated
'2': Programming of user selected options failed.
PROGRESS_END - End Operation.
Elapsed time = 13 sec.