Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

error in break statement by using disable statement

Status
Not open for further replies.

singla.vishal8

Newbie level 6
Joined
Feb 6, 2013
Messages
13
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,381
generate
begin : block1
for (h=0; h<24 ; h= h+1)
begin
assign a2 = a1 >> 1;
if (a2[0] == 1'b1)
disable block1;
end
end
endgenerate

It shows following Error:
Line 187: ERROR, Syntax error near ( disable ).
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top