Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Enable signal for Duty cycle adjusting circuit

Status
Not open for further replies.
N

nguyenvanthien

Member level 4
Joined
Oct 31, 2013
Messages
75
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,288
Activity points
1,833
Hi all,
I'm designing duty cycle adjusting circuit. I have finished it followed picture that I attached. However, I'd like to have enable signal in that designing. When the circuit is adjusting, enable =0, in the lock state, enable will go high (=1).
Do you have any suggestion?
Thank you very much!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top