Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

EAGLE Schematic....wish to highlight all Resistors.

Not open for further replies.



I am in Eagle schematic and i have resistors which are all R2, R3...etc etc......how do i highlight all resistors.....ie highlight "R" components.

I also made my own "net-connection" components, which i use to connect same nets which are too difficult to route with a direct connection (because i would end up criss cross'ing too many wires)......how can i highlight these "net-connectors".......at the moment i can find a net-connector, and then i'm spending ages trying to find the other net-connector of the same name that its connected to.

Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com