Could somebody quickly give me a hint how I can show a pin (name is known) in a schematic? "SHOW" command only shows component, not pin. I've read Eagle online help but couldn't find one.
I am not near my computer, so I am guessing. It is hidden in the general setup (one of the options on the top right menus). One of the tabs where you set various display options has a setting for 'show pin names'. I can check tomorrow if you are still stuck.
You really ought to look at the Eagle forum at Cadsoft - it is very good and busy.
Actually, the easiest way is the "find" ULP. Select ULP button then run "find.ulp". There you can search for nets, pins, values etc and also change them.