Displacement Sensor - Basic question

[gonsays]

Hello,

I have the datasheet of the HLS10B sensor and I'm having trouble getting:
-Input Range
-FS
-Output Range
-FSO

The datasheet is attached on this post.
View attachment APEK HLS10B.pdf


Thank you very much in advance

- - - Updated - - -

I forgot to mention that I think that FS=11mm and input range: 0-11mm, the problem is regarding the output range and FSO

 

[srizbf]

Hello,

I have the datasheet of the HLS10B sensor and I'm having trouble getting:
-Input Range
-FS
-Output Range
-FSO

The datasheet is attached on this post.
View attachment 117204


Thank you very much in advance

- - - Updated - - -

I forgot to mention that I think that FS=11mm and input range: 0-11mm, the problem is regarding the output range and FSO

the datasheet attached dont have much info.
it is a calibration sheet.
any other datasheet for the said transducer can give the reqd info.

 

[Vbase]

Hello,

I have the datasheet of the HLS10B sensor and I'm having trouble getting:
-Input Range
-FS
-Output Range
-FSO

The datasheet is attached on this post.
View attachment 117204


Thank you very much in advance

- - - Updated - - -

I forgot to mention that I think that FS=11mm and input range: 0-11mm, the problem is regarding the output range and FSO

You got it right. The displacement range is 11mm.
If you put 5V between red(+) and y/w, you will get between blue(+) and green 25mV for max displacement.
The max voltage you can put is 10V.

y/w was corrected to black, so check the colors of your sensor wires.