Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Displacement Sensor - Basic question

Status
Not open for further replies.

gonsays

Newbie level 5
Newbie level 5
Joined
Mar 25, 2015
Messages
10
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
83
Hello,

I have the datasheet of the HLS10B sensor and I'm having trouble getting:
-Input Range
-FS
-Output Range
-FSO

The datasheet is attached on this post.
View attachment APEK HLS10B.pdf


Thank you very much in advance :)

- - - Updated - - -

I forgot to mention that I think that FS=11mm and input range: 0-11mm, the problem is regarding the output range and FSO
 

srizbf

Advanced Member level 5
Advanced Member level 5
Joined
Apr 3, 2010
Messages
1,992
Helped
417
Reputation
840
Reaction score
329
Trophy points
1,363
Activity points
10,985
Hello,

I have the datasheet of the HLS10B sensor and I'm having trouble getting:
-Input Range
-FS
-Output Range
-FSO

The datasheet is attached on this post.
View attachment 117204


Thank you very much in advance :)

- - - Updated - - -

I forgot to mention that I think that FS=11mm and input range: 0-11mm, the problem is regarding the output range and FSO

the datasheet attached dont have much info.
it is a calibration sheet.
any other datasheet for the said transducer can give the reqd info.
 

Vbase

Full Member level 6
Full Member level 6
Joined
Apr 7, 2015
Messages
373
Helped
75
Reputation
150
Reaction score
75
Trophy points
28
Activity points
2,036
Hello,

I have the datasheet of the HLS10B sensor and I'm having trouble getting:
-Input Range
-FS
-Output Range
-FSO

The datasheet is attached on this post.
View attachment 117204


Thank you very much in advance :)

- - - Updated - - -

I forgot to mention that I think that FS=11mm and input range: 0-11mm, the problem is regarding the output range and FSO

You got it right. The displacement range is 11mm.
If you put 5V between red(+) and y/w, you will get between blue(+) and green 25mV for max displacement.
The max voltage you can put is 10V.

y/w was corrected to black, so check the colors of your sensor wires.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top