Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Different Configuration of Secondary side in Current Mode Controlled flyback Converter

Status
Not open for further replies.
S

sabu31

Advanced Member level 1
Joined
Jan 28, 2011
Messages
454
Helped
12
Reputation
24
Reaction score
13
Trophy points
1,298
Activity points
5,215
Dear All,

I would like to know the difference in functionality / use over the two secondary side configurations of the Flyback converter as shown in attached. One of them uses a zener. Are there any other configurations for secondary side which is also implemented. Also i request give links to references regarding the same . Thanking you.
 

Attachments

  • TI_config_TL431.pdf
    102.3 KB · Views: 56
  • TOPSwitch-JX_PIDesign1_CVmode1.pdf
    66.1 KB · Views: 106

The Christophe Basso book explains this to you.

The differences etc.

Book
"Designing control loops for linear and switching power supplies"
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top