Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Development Board with a lot of I/O

Status
Not open for further replies.

javad

Member level 3
Joined
Aug 18, 2004
Messages
57
Helped
2
Reputation
4
Reaction score
1
Trophy points
1,288
Activity points
495
Hi all,
I'm looking for a development board for Xilinx Virtex family (V-II, V-II pro and specially V-4) with over 320 I/O connectors.
I prefer the price less that $1000.
Thanks.
M. J.
 

Hi,
The only one I know off is this board from Hardi in Sweden:
**broken link removed**

it has:

# 1 Virtex-II Pro device, either XC2VP70 or XC2VP100 in an FF1704 package
# 958 available I/Os in eight 120-pin HAPS connectors
# 20 Rocket I/O channels + 360 LVDS pairs for fast I/O
# 2 embedded PowerPC processors
# Single 5V supply voltage
# Three different VCCO regions with independently configurable I/O voltage
from 1.5V to 3.3V
# 16 clocks
# Battery backed-up encryption key
# JTAG interface
# Use as a daughter board or stand-alone

But it is much more expensive than $1000 (I don't have their price sheet any more).

You can contact them to see if they can give you a quote.

Hope it helps,
bA ehterAm,
/Farhad

**broken link removed**
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top