Re: designing of SRR
Hello MAHENDRA BABU,
I suggest you to use Sonnet or AWR Microwave Office for SRR design & Analysis
Here is nice article on SRR using Sonnet
A novel bandpass filter based on complementary split rings resonators and substrate integrated waveguide
Wenquan Che *, Chao Li, Kuan Deng, Lisheng Yang
Department of Electrical Engineering, Nanjing University of Science & Technology, 210094 Nanjing, China
email: Wenquan Che (yeeren_che@yahoo.com.cn)
*Correspondence to Wenquan Che, Department of Electrical Engineering, Nanjing University of Science & Technology, 210094 Nanjing, China
Funded by:
National Key Laboratory Foundation of China; Grant Number: 9140C5306010707
National Science Foundation of China; Grant Number: 60471025
Keywords
bandpass filter • substrate integrated rectangular waveguide (SIW) • complementary split rings resonators (CSRRs)
Abstract
One novel bandpass filter implemented with combination of two different structures-complementary split rings resonators (CSRRs) and substrate integrated waveguide (SIW) is proposed in this article. Several CSRRs are etched on the surface of SIW to form the stopband with very sharp rejection. One prototype was fabricated, the measured results indicate 30% passband (at -15 dB return loss), the rejection band ranges from 6.4 GHz to 7.8 GHz, about 20% bandwidth at -20 dB rejection, the maximum rejection even reaches 50 dB. The rejection skirt is very sharp, only 18 MHz. © 2008 Wiley Periodicals, Inc. Microwave Opt Technol Lett 50: 699-701, 2008; Published online in Wiley InterScience (
www.interscience.wiley.com). DOI 10.1002/mop.23182
**broken link removed**
Also see the post for details on SRR...
---manju---