evalon
Member level 1
Hello
I'm in the process of designing a solar charger based on the LT3652 (see attachment). However, I'm not sure how to polarize C3.
Linear in their datasheet (see attachment) writes on p. 9 - boost pin - that the operating range of the boost pin relative to the switch pin is 0 to 8.5 volts. I'm just not sure if it is always 0 to + 8.5 volts or it's an AC value. The LT3652's block diagram is on p. 9.
I'd appreciate your feedback.
Best regards,
Jesper
I'm in the process of designing a solar charger based on the LT3652 (see attachment). However, I'm not sure how to polarize C3.
Linear in their datasheet (see attachment) writes on p. 9 - boost pin - that the operating range of the boost pin relative to the switch pin is 0 to 8.5 volts. I'm just not sure if it is always 0 to + 8.5 volts or it's an AC value. The LT3652's block diagram is on p. 9.
I'd appreciate your feedback.
Best regards,
Jesper