Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Design of a folded cascode opamp....

Status
Not open for further replies.

Rcy

Junior Member level 1
Joined
Sep 17, 2010
Messages
16
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Activity points
1,389
I have designed a folded cascode opamp.... so if i connect a feedback resistance and an input resistance to the inverting terminal, will it act like an inverting amplifier.....
 

Sure, if your operation points are correct (inputs within common mode range). Care for enough phase margin if you use it in low gain configuration.
 

    V

    Points: 2
    Helpful Answer Positive Rating
u'd better to have a driving stage to drive resistor load unless it is large.
 

cascode structures drastically decrease the output signal swing.....make sure your circuit performs as desired......
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top