vlsi_freak
Full Member level 2
Design begining.
Hi Friends...
Here in this forum we had been talking a lot about timing, multicycle path etc etc..bla bla bla.....
My doubt is, before we begin any design say 50 MHz, or 60 MHz or any thing, how we will get a rough idea that my design will run in that frequency. If we dont have an idea of rough frequncy of our target will run, its going to be a wilds goose chase, because once our design is coded and its not running...AAHHHHH...
The company will come to ruins.
Plz share your views.
Regards
freak
Hi Friends...
Here in this forum we had been talking a lot about timing, multicycle path etc etc..bla bla bla.....
My doubt is, before we begin any design say 50 MHz, or 60 MHz or any thing, how we will get a rough idea that my design will run in that frequency. If we dont have an idea of rough frequncy of our target will run, its going to be a wilds goose chase, because once our design is coded and its not running...AAHHHHH...
The company will come to ruins.
Plz share your views.
Regards
freak