Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I know the @ltara FLEX FPGA configuration mechanism using MCU(PS Mode), could anyone tell me if the Cyclone configuration mechanism is the same as FLEX? Thanks in advance.
It is possible to config a Cyclone devices in PS (passive serial) mode. For detailed information you should read Chapter 13. Configuring Cyclone FPGAs.
Thank you for the quick reply. I read the doc you recommended, and I think the configuration mechanism for Cyclone devices is the same as FLEX devices. I will try it later.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.