Cyclone configuration using MCU

[cdcll]

I know the @ltara FLEX FPGA configuration mechanism using MCU(PS Mode), could anyone tell me if the Cyclone configuration mechanism is the same as FLEX? Thanks in advance.

 

[cube007]

Hello cdcll,

It is possible to config a Cyclone devices in PS (passive serial) mode. For detailed information you should read Chapter 13. Configuring Cyclone FPGAs.

Bye,
cube007

 

[cdcll]

TO cube007:

Thank you for the quick reply. I read the doc you recommended, and I think the configuration mechanism for Cyclone devices is the same as FLEX devices. I will try it later.

BR,
cdcll

 

[cdcll]

I have tried to configure the Cyclone device using the same mechanism as for FLEX device, it works properly!