Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

create database from existing design in OrCad CIS

Status
Not open for further replies.

pavel47

Member level 4
Joined
Nov 8, 2005
Messages
68
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
Switzerland
Activity points
1,790
Hello

In my design I have 3 schematics. I want to create database from whole design.
But when I try to create CIS Bill of materials, it creates only liste from "active" schematic.
It there a possibility to create CIS Bill of materials from whole design?

Thanks in advance.

Pavel.
 

Uky

Member level 5
Joined
Sep 3, 2004
Messages
83
Helped
18
Reputation
36
Reaction score
4
Trophy points
1,288
Location
Swedish West Coast
Activity points
1,205
Close the schematics. Point to the "Root" of the schematic tree. Then Tools (or Reports - I don't remember) and then CIS Bill of materials. This should work if the schematics are created as pages under the root design.
 

pavel47

Member level 4
Joined
Nov 8, 2005
Messages
68
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
Switzerland
Activity points
1,790
Thank for answer

Unfortunately my schematics are created as pages in different directories:
Design (.dsn)
\Schem1
page1
\Schem2
page1
\Schem3
page1
The purpose of this ierarchy was to have independent annotation for each PCBs.
When I point to the Root (Design .dsn), and create CIS Bill, it take only 1st Schematic which is marked as Root.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top