I need to increase copper thickness in all the layers in PADS. So, in layer setup---->thickness dialog box. I have component,substrate(prepeg),coating for all the layers. which parameters I need to change to increase the thickness of copper. I am attaching a image with this mail.
you have to speak to manufacturer because they only have standard pre-preg and core thickness,depending on core and pre-preg and depending of power consume
of the trace it will vary.ususally copper thickness 1 oz (1.4 mil )
I don't understand your question. You simply enter the thickness you want for the layers you want. It's all right there in front of you. Obviously, you don't want to change the thickness of your prepreg, so what's left???
Prepreg and substrate are the non-copper layers of pcb construction. I'm not really sure of the distinction between "prepreg" and "substrate". Prepreg is a specific type of material (for instance, fiberglass and epoxy). Any non-conducting material could be considered a 'substrate', I think, but not every substrate is prepreg.