Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Conventional fan controls I've seen here use capacitor-start to start the motor and a simple potentiometer in the switchboard to control the voltage to the fan thereby changing it's speed.
The most ancient speed controls used an L-pad. Simple, fairly
low loss, and hard to find anymore.
Inductive loads can be controlled by triac / SCR dimmer styles
but there is more voltage applied at the current-zero-crossing
which the design has to accommodate (lamp dimmers have it
easy). This is really just component selection (but you need
to have the right goals).
There's a lot of stuff out there on "triac induction motor speed
control".
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.