Circuit simulation using MWO

[sekharareddy]

Hello All,
Can anybody tell me how to connect the ports in MW office to a circuit which is having

Device-1:Transceiver with differential impedance of 100Ω
Device-2:Balun with 200Ω balanced impedance and 50Ω unbalanced impedance

For this, If I consider the impedance values of Transceiver is enough.
Please find the attached S-parameter-1 file for information.





[/img]

 

[Manjunatha_hv]

Hello sekharareddy,

I am back...

There are two main ways to generate differential signals in the AWR
Design Environment. The difference between them is really in the
circuit topology being simulated.

See the attached PDF document...
Similar way you cannect your S-Parameter file...


---manju---

 

[sekharareddy]

Hello Manju,

Thanks for the information.

I have simulated the MMconv and XFMRTAP as per your document,its working fine.In my case differential impedance is 100Ω and unbalanced impedance is 50Ω. So, I want go with the XFMRTAP option.But in that, Even if I keep the Transformer turns ratio as 1 on both sides I'm getting the results.
Shall I proceed by keeping the turns ratio (on both sides)as 1? Also can u just go through the Impedance values document of My transceiver, I have attached above? Can you suggest me how to proceed further on this?