Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Can't print the bottom layer in Altium Designer 10.7

Status
Not open for further replies.

goldperson2005

Junior Member level 2
Joined
Nov 8, 2011
Messages
21
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,420
I use this version but I cant get right output .
In print preview I cant see bottom layer .
 
Last edited:

loosemoose

Full Member level 5
Joined
Dec 9, 2008
Messages
319
Helped
128
Reputation
258
Reaction score
115
Trophy points
1,323
Location
Vancouver, BC
Activity points
2,662
Re: Altium Designer 10.7

Have you set it up properly in the "Page Setup"?
Go >>File >> Print Setup , then select "Advanced". In this panel you need to setup the appropriate layers to print.
Right click in the white area to get add layers and printout.

K
 

PCBcomponentlibraries

Advanced Member level 4
Joined
Oct 14, 2011
Messages
102
Helped
43
Reputation
86
Reaction score
42
Trophy points
1,308
Location
Cheshire, UK
Activity points
1,809
Re: Altium Designer 10.7

Output job files are really good for this kinda thing - **broken link removed**

You can save them as a template also so that you don't have to configure it every time.

Hope this helps,
Chris.
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top