oermens,
I believe that calibre is installed...And i say "i believe",because it was set up by another person in our lab that i cannot contact anymore and find out what is going on...I will tell you what i see and you will judge if it is properly installed or not.Well in my .cshrc file i have the above lines
setenv MGC_HOME /cad/mentor/calibre/ixl_cal_2007.2_34.24
set path = ($MGC_HOME/bin $path)
setenv LM_CALIBRE_LICENSE_FILE ...
There is a calibre menu in virtuoso,i show it to you at the attached screenshot below,but i do not know how to set it up (give the compare cdl rules file,the switches etc.).Additionaly i can't find the menu that a1s7trea suggested.
I would appreciate if you could guide me with some detailed steps to setup the LVS run.Thank you in advance.
Regards,
Jimito13