NikosTS
Advanced Member level 4
Hello everyone,
After placing and routing a design , i see that the pins are not covered by the metal layer that was used for the routing. This results in DRC errors when the design is imported in Cadence Virtuoso.
Is there any way ( option for example ) that can fix this problem? On my design there are around 160 pins so it will take quite some time to fix them manually.
Thank you in advance
After placing and routing a design , i see that the pins are not covered by the metal layer that was used for the routing. This results in DRC errors when the design is imported in Cadence Virtuoso.
Is there any way ( option for example ) that can fix this problem? On my design there are around 160 pins so it will take quite some time to fix them manually.
Thank you in advance