Dan_Kolis
Newbie level 4
Hi
I am trying to turn off optimization using CCS compiler with MPLAB as a front end for Microchip 18F252 development.
Single stepping is brutally hard with yellow "can't get there" question marks all over. I tried:
From MPLAB which calls CCS:
Project | Build Options | Project | CCS Compiler
select catagory : Optimization
set slider to "Low"
options that creates is:
+DF +LN +T +A +M -Z +Y=0 +EA
[ ] Inherit global settings { not checked }
MPLAB version: 8.87
CCS Complier version: PCH 4.134
the various sources say this goes away and one can step the C code if optimization is turned off. That is the +Y=0 setting says the PDF.
Anybody know / can tell us/me how to do this?
Thank you for even reading my sorry plight.
Regards
Dan K
I am trying to turn off optimization using CCS compiler with MPLAB as a front end for Microchip 18F252 development.
Single stepping is brutally hard with yellow "can't get there" question marks all over. I tried:
From MPLAB which calls CCS:
Project | Build Options | Project | CCS Compiler
select catagory : Optimization
set slider to "Low"
options that creates is:
+DF +LN +T +A +M -Z +Y=0 +EA
[ ] Inherit global settings { not checked }
MPLAB version: 8.87
CCS Complier version: PCH 4.134
the various sources say this goes away and one can step the C code if optimization is turned off. That is the +Y=0 setting says the PDF.
Anybody know / can tell us/me how to do this?
Thank you for even reading my sorry plight.
Regards
Dan K