Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] Bias tee and resistor decade box - Suggestion

Status
Not open for further replies.

palmeiras

Full Member level 6
Full Member level 6
Joined
Feb 22, 2010
Messages
375
Helped
61
Reputation
122
Reaction score
50
Trophy points
1,308
Location
South America
Activity points
4,199
Hello Guys,

Please, I need to buy a Bias tee to bias a source follower (Connector 1: RF + DC, Connector 2: DC (input) and Connector 3: RF (output - connect it in the spectrum analyzer).
The RF signal is 2.5 GHz.

Do you have a suggestion of a good brand and where to buy it?

I also need a variable load (like resistor decade box with BNC connection), where the resistance varies from 50 to 50 kohm. Do you have a suggestion?

Thank you so much,
 
Last edited:

have not used a decade boxy in ... decades. They have so much wire length inside of them that they are fairly useless in modern electronics, even a simple op amp will oscillate with one in the circuit.
 
easy way to do your own decade box
resistance : **broken link removed**
capacitors : **broken link removed**
hope this helps.
 
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top