maks11
Newbie level 4
holla guys,
I am trying to simulate n perform circuit of voltage to frequency converter using 555 and 741 in multisim 12, facing some problems in simulation..
1. when i applied input of 741 to ic555 i am not getting desired o/p
2. when i check o/p of 741 its square wave and when I applied it to 555 its came like image shows
i am totally stuck n dont knw where to start.
required suggestions, corrections, or i can perform this same task using any different circuit?
Find attachment for circuit diagram which i used n simulation results
![22.JPG 22.JPG](https://www.edaboard.com/data/attachments/56/56829-0884a42e79a0a073603b8ec815c7b0bd.jpg)
![11.JPG 11.JPG](https://www.edaboard.com/data/attachments/56/56828-4a195b48be11671d0860cfbecf24700b.jpg)
![135-10381.png 135-10381.png](https://www.edaboard.com/data/attachments/56/56827-c74cecafe50f0c7e140453c55ca06b70.jpg)
I am trying to simulate n perform circuit of voltage to frequency converter using 555 and 741 in multisim 12, facing some problems in simulation..
1. when i applied input of 741 to ic555 i am not getting desired o/p
2. when i check o/p of 741 its square wave and when I applied it to 555 its came like image shows
i am totally stuck n dont knw where to start.
required suggestions, corrections, or i can perform this same task using any different circuit?
Find attachment for circuit diagram which i used n simulation results
![22.JPG 22.JPG](https://www.edaboard.com/data/attachments/56/56829-0884a42e79a0a073603b8ec815c7b0bd.jpg)
![11.JPG 11.JPG](https://www.edaboard.com/data/attachments/56/56828-4a195b48be11671d0860cfbecf24700b.jpg)
![135-10381.png 135-10381.png](https://www.edaboard.com/data/attachments/56/56827-c74cecafe50f0c7e140453c55ca06b70.jpg)