radoboy
Newbie level 1
balun simulation
Hi,
I'm trying to match Zs = 60 + j164 ohm differential output, to a 50 ohm connector RPSMA of a CC2430 chip. The matching network should be balun, made of lumped elements inductors and capacitors. I've used AppCAD to find the parts of the balun but when I make the simulation with Ansoft Designer on the Smith chart I get
strange results and I'm not shure if my schematic in designer is right.
The problem is that I don't know how to set the differential output in designer.
If anyone have solution or idea please post a message.
Thanks in advance
Hi,
I'm trying to match Zs = 60 + j164 ohm differential output, to a 50 ohm connector RPSMA of a CC2430 chip. The matching network should be balun, made of lumped elements inductors and capacitors. I've used AppCAD to find the parts of the balun but when I make the simulation with Ansoft Designer on the Smith chart I get
strange results and I'm not shure if my schematic in designer is right.
The problem is that I don't know how to set the differential output in designer.
If anyone have solution or idea please post a message.
Thanks in advance