Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Balun simulation with Ansoft Designer

Status
Not open for further replies.

radoboy

Newbie level 1
Joined
Mar 5, 2006
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,288
balun simulation

Hi,
I'm trying to match Zs = 60 + j164 ohm differential output, to a 50 ohm connector RPSMA of a CC2430 chip. The matching network should be balun, made of lumped elements inductors and capacitors. I've used AppCAD to find the parts of the balun but when I make the simulation with Ansoft Designer on the Smith chart I get
strange results and I'm not shure if my schematic in designer is right.
The problem is that I don't know how to set the differential output in designer.
If anyone have solution or idea please post a message.
Thanks in advance :)
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top