Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Auto routing in Allegro16.0

Status
Not open for further replies.
P

pcb87

Member level 1
Joined
Oct 24, 2007
Messages
40
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,529
Hi all

Can anyone tell me about auto routing features in allegro 16.0

---------- Post added at 12:11 ---------- Previous post was at 12:06 ----------

How to set a constraint for a particular region...am working on a 10 layer board.using a 500+ pin BGA.created a region and set constraints for routing BGA.But while auto routing it is not using the same via specified for that region.Anyone know the reason.??
 

Hi PCB ,

better use manual routing in BGA (via to BGA ball gap must be keep carfully or else it is not working )
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top