Can anyone help me in autoruoting in allegro16.0
I have routed PCB's manually only.
So i am not familiar with the constraint settings which are to be given while auto routing the board.presently i'm working on motherboard.
it needs to meet with several constraints like etch length,impedence etc.
For Board with Hign numbers of constraints it is prefered to route manually . But if you are working on SPB16.0 and you have license of Global Route Environment then your can atleast bundle your BUS routes properly guide them and finish the BUS routing easily. But you should have GRE fro that.
why don't you use script for routing and do some section using script and some section using mannually. i did in our complex board this way after that we otimized it to 98% using script. my board is 16 layer
Script is good and quite easy also,