Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have got the 89c51snd1c chip i have designed a development board for it and tried to program the flash but its not working Atmel datasheet says the chip is shipped with a programmed bootloader i think i have to program it parallely does anyone know how to do it? i dont have access to a device programmer
Hi, I have a new version of the library with sourcecode and full documentation ( HTML format ). This was in the sorin7486's webpage into other zip file. Visit his page for more info about AT89C51SND1 and dedicated forum.
I'm trying to get ISP to work through USB in Windows XP but nothing seems to work. It gets picked up by Windows but only as a unknown device. I did try installing the drivers supplied with FLIP but with no success. Is it possible that the USB boot loader is not pre loaded?
I desparetely need some help. I'm using the AT89C51SND1C. I want to program it using FLIP with ISP. ISP pin is grounded, Windows XP picks it up but only as a "unknown device". I've tried installing the drivers in the flip/usb folder but with NO success. Please help!!!