Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Aoyue 908 - Temperatures Chart

Status
Not open for further replies.

brunofunchas

Full Member level 3
Joined
Jul 1, 2009
Messages
165
Helped
10
Reputation
20
Reaction score
7
Trophy points
1,298
Location
Portugal
Activity points
2,331
Hi,

I have an Aoyue 908 and I would like to know if anyone has a chart where we could see the position of the two knob for each type of electronic component, e.g.:

Capacitor: "Air flow" in position 3 And Heater in position 4.

Resistor: "Air flow" in positon 2 And Heater in positon 4

I would like to know also the temperatures that I shoul use.

Picture of the station:
don't post links to eshops, they are considered spammed advertisement.
Link to eshop replaced with picture of the product [alexan_e]
90908.jpg


Thanks in advance,
Bruno

---------- Post added at 17:06 ---------- Previous post was at 16:55 ----------

Hi,

Another question about thus equipment:

When I connect the power cord the diaphragm pump starts to work immediately, even if the two switches of the station are turned off!

Is this normal operation?

Thanks in advance,
Bruno
 

alexan_e

Administrator
Joined
Mar 16, 2008
Messages
11,895
Helped
2,021
Reputation
4,158
Reaction score
2,032
Trophy points
1,393
Location
Greece
Activity points
64,375
I had the same question a while ago,
https://www.edaboard.com/threads/195093/

You have to experiment , there is no correct solution.
I use it for de-soldering only, for me a temperature of about 380° with an airflow of about 4-5 works fine

Alex
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top