Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

antenna results combining (simulated and measured)

Status
Not open for further replies.

m11vajju

Newbie level 6
Joined
Jan 26, 2011
Messages
12
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,354
need help in combining the results of an antenna simulated and measured.antenna simulated in CST microwave studio and tested in network analyzer for VSWR and radiation patterns in anechoic chambers
 

jiripolivka

Advanced Member level 5
Joined
May 21, 2010
Messages
2,832
Helped
831
Reputation
1,660
Reaction score
802
Trophy points
1,393
Location
Santa Barbara
Activity points
22,012
The term "combining" I think is not correct. You can simulate an antenna, then you can make it and test it in real environment.
The results can be plotted to see how well your simulation agrees with the real thing. This is named "corroboration" or comparing the data.
No combination of both results is reasonable. You can either show your simulation , or, your real work.
 

randomflake

Newbie level 1
Joined
Apr 14, 2012
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,285
I believe m11vajju would like to import measured results (from a network analyzer / anechoic chamber, say) into Microwave Studio and plot it on the same graph as the simulated results. I would also like to to this, but have not found a way to import the data.
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top