Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Andes 2 - Strange optimized results

Status
Not open for further replies.
E-design

E-design

Advanced Member level 5
Joined
Jun 1, 2002
Messages
2,014
Helped
507
Reputation
1,016
Reaction score
408
Trophy points
1,363
Activity points
14,193
I am using Ansoft's designer 2 to optimize a oscillator design. I am optimizing phase noise at 1k & 10k. Now the optimizer improves the PN figures from my design values. When I re-run the non linear simulation with these updated optimized values, the PN degrades by about 4dB? Running the optimizer again, improves the PN by 4dB without changing it's previous optimized values. The optimizer is set to update design values automatically. I also tried it with the various optimizer algorithms, same result. Any ideas?

Thanks, E
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top