Analog Interface units for PLC /automat controls

Status
Not open for further replies.
V

vimalkhanna

Full Member level 6
Joined
Aug 7, 2010
Messages
322
Helped
55
Reputation
110
Reaction score
53
Trophy points
1,308
Location
delhi
Activity points
3,224
I need to design Analog 0-2.5VDC //0-1VDC input to 4-20mA digital/analog control for PLC feedback.
Conveyance thru RS232 /485 reqts are a must since the sensor and control are more than 100mtrs away.
Data display of blind /set values also needed.
 

What is the PLC device you use.
Can you draw a simple block diagram of that system you are designing.

Regards KAK
 

Will get back to you with a sketch of the required version.The sensor and control are in a different room(supervisors)and the PLC(national ) is on the automat .which is in the workshop.
The managers room is needing an overall inndication of the effected control signal.
 
Last edited:

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…