nandithaa_m
Junior Member level 3
The current source is to be designed to work with a 5 volt power supply. The current is to be set with an external resistor of value 100-500K. The 100K ohm resistor is to correspond to (about) 10 micro amps and the 500K to (about) 2 micro amps. The output resistance of the current source is specified at over 50 M. The output must function over the range of 1.4 to 5.0 volts. Finally, it is specified to have less than an 8% peak variance with a 2.5 to 5.0 volt impulse on the output side.
Design your circuit using the 1 micron models.
can any one gimme the idea of what I have to do???
If you want the models I can post them.
Design your circuit using the 1 micron models.
can any one gimme the idea of what I have to do???
If you want the models I can post them.