Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Altium Split Planes and Antenna

Status
Not open for further replies.

TiagoRibeiro

Full Member level 2
Joined
Oct 29, 2013
Messages
130
Helped
18
Reputation
36
Reaction score
17
Trophy points
28
Location
São Paulo/Brazil
Activity points
765
Hello,
I'm designing a multilayers board with top, bottom (Signal) and two mid planes(Power Plane and GND Plane).
My doubt is if I will have a problem with the bluetooth and wifi modules because these planes?
In the "Power Plane" I left a separate area of plane split with "No Net" for soldering the modules, but in the "GND plane" I am not able to do that. The Altium does not modify the net on this area of the plane, I get to choose the "No net", but he returns to "GND" option. I do not know what to do.
Can anyone help me with this?
Many thanks.:D

Tiago Ribeiro
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top