I see the solder mask in my design is missing for most components.
For example I have the following component in my design (Image 1). When I enable top layer I can see the component and blue colour in ISO_RLY_BAT- is nothing but the net colour.
When I enable the top solder mask and paste mask I dont see the solder mask. I can see only the paste mask. I have also disabled paste mask layer only and enabled solder mask and still I can't see the solder mask for most of the components.
But when I checked for the same part in my library I can see the solder mask.
I have also tested by placing this component in a new Altium PCB board and I can see the solder mask. Which means something is wrong with my existing design. May be some settings?
Below is the image that shows the above component placed in another PCB board.
Below is the image that shows my current settings.
Sorry, I am unable to help you regarding this issue. I think you will get help if you ask your question at the Altium support forum. I think they can give you a better guideline: https://www.altium.com/support
You can also ask your questions at https://www.pcbway.com/project/questionpublish
Many qualified PCB designers are there. They may know the solution.
If it's at a component level:
Try deleting the component from the PCB and re-Updating the PCB from the schematic.
(Or try Right Click > Component Actions > Update PCB Components from PCB Libraries)
I also find swapping to 3D is an easier way to inspect suspected issues with the soldermask layer: