I've routed the bottom layer for my PCB...
then I tried to print the layout to a paper...
problem is:
why the printing is FIT PAGE?? and not showing the real size of each components.
any settings should I apply???
I dont want to open new thread so I will ask here for my problem.
When I set scale on 1, my print is smaller than it should be. I dont know why. With couple of tries I have established that good print is on scale 1.01, and corrections for x (and y) are also on 1.01. Can anyone tell me why is this happening?
Thanks
I also faced same problem, when I set the scale print to 1, my print ( both horizantal and vertical) showing some difference with physical board. But I was thinking 1 to 1 print means we have to set the scale 1.1 .