gary36
Full Member level 4
Hi
I have a custom made legacy power pc board which has a dedicated serial (DB9) and UART-USB bridge from FTDI. I am able to send data from uboot prompt in both to DB9 and UART-USB(accessed via VCOM in PC). When I run an application (linux), I can see data through DB9 (by sending data stream to tty0). However I am unclear about sending the same data stream over UART-USB. I guessed as tty1, but the system crashes. Any clues?
I have a custom made legacy power pc board which has a dedicated serial (DB9) and UART-USB bridge from FTDI. I am able to send data from uboot prompt in both to DB9 and UART-USB(accessed via VCOM in PC). When I run an application (linux), I can see data through DB9 (by sending data stream to tty0). However I am unclear about sending the same data stream over UART-USB. I guessed as tty1, but the system crashes. Any clues?