Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

A problem about PSTB analysis

Status
Not open for further replies.
D

daisyinfall

Junior Member level 3
Joined
Nov 2, 2005
Messages
27
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Activity points
1,485
Hello,

When I try a PSTB simulation, I enable PSS analysis first.
After then, I go to the PSTB window, it need a "Probe Instance" there.

So I add a DC Vlotage Source "VDC" (0 V) into my loop, and click "Select" to go to schematic choose this VDC.
But there is an error happening "PSTB can't find component '/I0/V1' in the design".

I am confused, am I wrong?

Anyone who has used PSTB can give me a help? Thanks a lot!

Best regards!
 

Attachments

  • PSTB.JPG
    PSTB.JPG
    81.3 KB · Views: 105

I think that a dc voltage source is not accepted by this type of simulation,correct me somebody else if i am wrong.
Use an iprobe component from analogLib instead.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top