dabby21
Advanced Member level 4
- Joined
- Aug 8, 2011
- Messages
- 114
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,296
- Location
- Philippines
- Activity points
- 2,232
anyone could explain the pin configuration of 3310 LCD? how can can i connect them with pic? is it possible with port D?and can anyone provide schematic interface in pic18f4620. thank you.
**broken link removed**
regarding this link, i do understand how the 3310 works with pic18, but its in micro c. can this program run in c18? cause ive tried many programs written in micro C and fail to run on c18. plus the library of functions that the shobit(the author) gave was in micro C. if only i can include his functions in c18, i can somehow manage to manipulate outputs on 3310.
sir, just a question, in this program, is there any unique attributes on every designated RB ports that it assigned or i can freely assigned any of the ports to connect them in equivalent on the pins of 3310? like sclk,sce,res, i can freely assign them to any of the ports in PORT D?
17.4 I2C Mode
The MSSP module in I2C mode fully implements all
master and slave functions (including general call
support) and provides interrupts on Start and Stop bits
in hardware to determine a free bus (multi-master
function). The MSSP module implements the standard
mode specifications, as well as 7-bit and 10-bit
addressing.
Two pins are used for data transfer:
• Serial clock (SCL) – RC3/SCK/SCL
• Serial data (SDA) – RC4/SDI/SDA
The user must configure these pins as inputs or outputs
through the TRISC<4:3> bits.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?