Goher
Junior Member level 2
Dear All,
I really cant find the suitable words to thank you about your continuous support , that was is really very kind of you.
i found some confusing check boxes in the solution setup (under the eigenmode solution type) that i don't know if i should check them or leave them without checking, these check boxes are:
Π Converge on real frequency only
Π Do Lambda Refinement
Π Use free space lambda
Π Use low-order solution basis
I tried to read the user manual to figure out what those do but i found it confusing.
Would you please also give me some suggested values to set up those parameters if i need to simulate the following:
1- A simple Cylinder with 4cm radius and 2cm height that operates in the range of 1 GHz to 26 GHz.
2- A magnetron cavity that works in the range of 9 GHz to 30 GHz.
Thank you so much in advance for helping me again
Best Regards,
Goher
m_goher@yahoo.com
I really cant find the suitable words to thank you about your continuous support , that was is really very kind of you.
i found some confusing check boxes in the solution setup (under the eigenmode solution type) that i don't know if i should check them or leave them without checking, these check boxes are:
Π Converge on real frequency only
Π Do Lambda Refinement
Π Use free space lambda
Π Use low-order solution basis
I tried to read the user manual to figure out what those do but i found it confusing.
Would you please also give me some suggested values to set up those parameters if i need to simulate the following:
1- A simple Cylinder with 4cm radius and 2cm height that operates in the range of 1 GHz to 26 GHz.
2- A magnetron cavity that works in the range of 9 GHz to 30 GHz.
Thank you so much in advance for helping me again
Best Regards,
Goher
m_goher@yahoo.com