turuk
Junior Member level 3
Hi,
In my antenna design, for more than 3,6 billion cells required and when i try to run the program i got this error message
"Simulation setup for 3.6 billion mesh cells requires:
- MPI simulation setup with at least 2 cluster nodes
Simulation cannot be started."
Is there any of you faced with the same problem? Even for the reduced number of cells it cannot run the program plus i dont wana use less number of cells since it affects the results.
Any advice would be really helpful
Thanks in advance
In my antenna design, for more than 3,6 billion cells required and when i try to run the program i got this error message
"Simulation setup for 3.6 billion mesh cells requires:
- MPI simulation setup with at least 2 cluster nodes
Simulation cannot be started."
Is there any of you faced with the same problem? Even for the reduced number of cells it cannot run the program plus i dont wana use less number of cells since it affects the results.
Any advice would be really helpful
Thanks in advance
Last edited: