tiwari.sachin
Full Member level 6
Hello,
I am using 74LCX573 whose inputs are connected to MCU while the output control a device (lets consider Leds for example)
When I powerup (ie MCU is in reset for about 1200ms and then activates), the outputs of latch are high even when the inputs are low and once the MCU is active, it all works fine.
My requirement. The outputs of latch should be low during powerup.
The Latch pin is connected to MCU. The output enable pin is grounded.
What can I do so that the output of latch are 0 on powerup.
I am using 74LCX573 whose inputs are connected to MCU while the output control a device (lets consider Leds for example)
When I powerup (ie MCU is in reset for about 1200ms and then activates), the outputs of latch are high even when the inputs are low and once the MCU is active, it all works fine.
My requirement. The outputs of latch should be low during powerup.
The Latch pin is connected to MCU. The output enable pin is grounded.
What can I do so that the output of latch are 0 on powerup.