urnuj
Junior Member level 3
Hi
The MCU is pic33ep512MU814 and it is being compiled and debugged using MPLABX and XC-16.
I have set it up in a while loop with a timer interrupt to handle some processes.
The program is able to run normally when it is being debugged but it is halted due to a break in user code after 100 over seconds.
Is there a reason that it is not able to continue running and being caused to stop?
Regards
The MCU is pic33ep512MU814 and it is being compiled and debugged using MPLABX and XC-16.
I have set it up in a while loop with a timer interrupt to handle some processes.
The program is able to run normally when it is being debugged but it is halted due to a break in user code after 100 over seconds.
Is there a reason that it is not able to continue running and being caused to stop?
Regards