Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to run LVS of mixed-signal circuit normally?

Status
Not open for further replies.
H

harryzhu

Member level 3
Joined
Oct 9, 2004
Messages
59
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
627
Hi,

I'm not sure how to run LVS of mixed-signal circuit. My digital part is verilog code and analog part is schematic, after I finish the whole chip layout, I wanna run LVS using calibre, but I don't know how to do it. I need one spice netlist, but how to get it? Thanks for your help!

Best Regards,

Harryzhu
 

Dump your verilog gate level netlist,
then transfer it to calibre view.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top