Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

PADS Logic ECO2PCB not sending decal/part that has pin count = 0, help?

Status
Not open for further replies.
1

150c_vapour

Newbie level 1
Joined
Feb 25, 2012
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,287
I have created a "barcode" part, with 0 pins, and a decal that is a silkscreen box with text. Add to schematic, attempt to send schematic to PADS Layout, barcode decal does not appear, urge to violence rises. I have a feeling there is a check box somewhere that is preventing this but I cannot seem to figure it out. Can anyone help? Much appreciated!!
 

What layer is your decal text and box on? Is that layer turned on? (ctrl-alt-c, and select the layer and color for the elements).

When you did your forward annotation, did you confirm the part was actually added to the PCB?

As a test, try adding the part manually in Layout, and see if that works.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top